The Impact of Wind Movement on Providing Thermal Comfort in Urban Design

Authors

  • Hala Hussein Musa Architectural Engineering Department, College of Engineering, University of Baghdad, Baghdad, Iraq
  • Fawzia Asadi Architectural Engineering Department, College of Engineering, University of Baghdad, Baghdad, Iraq
  • Anas Hameed Majeed Architectural Engineering Department, College of Engineering, University of Baghdad, Baghdad, Iraq.

DOI:

https://doi.org/10.47577/technium.v24i.11740

Keywords:

Wind movement, thermal comfort, ENVI-met Models program, sustainable urban environment

Abstract

 The wind movement is a crucial factor in enhancing thermal comfort, forming an essential part towards friendly and sustainable urban environment. Air movement, as a prominent climatic factor, reduces heat stress with improving ventilation quality. Effective natural ventilation and heat stress mitigation can be achieved by orientation, planning and shaping the urban blocks in urban environments. Air movement represents the most important element in improving environmental adaptation, as the rapid airflow reaching buildings can significantly reduce their temperature. Site planning requires precise knowledge of the main wind directions and speeds. The research utilized the ENVI-met Models program for modeling urban environments and predicting thermal effects in the built environment. This program plays a crucial role in understanding and analyzing environmental conditions and their impact on thermal comfort. The research addressed the knowledge gap and lack of local studies in highlighting the role of wind movement in enhancing thermal comfort in urban environments using ENVI-met Models. The research aimed to provide specific knowledge in measuring wind movement and its role in enhancing thermal comfort in urban environments using the program. The research hypothesized that analyzing and modeling wind movement with ENVI-met Models can effectively contribute to understanding and improving thermal comfort in urban environments. One of the key findings is that studying the impact of wind movement with this program is essential for providing scientific and technical foundations to improve urban design and enhance thermal comfort in urban areas, promoting sustainability and environmental quality in cities

References

Hala, H. M., Fakhreddine, H. S., Najah, F. T., & Abd, H. J. (2023) ‘Improving Thermal Comfort in the Outdoor Spaces of Universities through Planning: Corridors of the University of Al-Farahidi, Iraq’, ISVS e-journal, Vol. 10, Issue 10, October 2023. Available at: https://isvshome.com/e-journal_10-10.php

Landsberg, E. (1981) The Urban Climate, Maryland: Academic Press.

Bahjat, R. S. (2006) ‘Some Peculiarities of Contemporary Arab Dwelling in Hot-Arid Regions’, College of Engineering, University of Baghdad, p. 4.

Standard A (2004) Thermal Environmental Conditions for Human Occupancy, ANSI. American Society of Heating Refrigerating and Air-Conditioning Engineering, INC.

Hala, H. M .et al .(2022) Phases of Urban Development Impact on the Assessment of Thermal Comfort: A Comparative Environmental Study, Civil Engineering Journal, 5(8), pp.951– 966. Available at: : https://www.civilejournal.org/index.php/cej/article/view/3424

Al-Bazzaz, I. (1990) ‘Using Solar Energy in Iraqi Buildings’, Master’s Thesis, College of Engineering, Department of Architecture, University of Baghdad, pp. 75-77.

Almatarneh, R. T. (2013) ‘Sustainability Lessons Learnt from Traditional Architecture: A Case Study of the Old City of As-Salt, Jordan’, IOSR Journal Of Environmental Science, Toxicology And Food Technology (IOSR-JESTFT), 5(3), pp. 101.

Zainab, I. A. et al. (n.d.) ‘Enhancing the Aesthetic Aspect of the Solar Systems Used as Facades for Building by Designing Multi-Layer Optical Coatings’. Available at: https://doi.org/10.47577/technium.v3i11.5324

Al-Assadi, F. I. (2013) ‘The Solar Technology and its Effect on in the Formal Configuration of Buildings’, Journal of the Association of Arab Universities, Issue 1, Volume 20, pp. 77-98.

Almansuri, A. A. et al. (2019) ‘The Effects of Passive Design and Renewable Energy in Producing Low Energy Efficiency Architecture and Special Identity’, University of Salford.

Freewan, A. A. Y. (2019) ‘Advances in Passive Cooling Design: An Integrated Design Approach’, p. 3.

Al-Assadi, F. I. and Hasan, I. (2009) ‘Green Architecture’, The 6th Engineering Conference, College of Engineering, Architectural Engineering, Volume II. Available at: https://www.researchgate.net/publication/367150400_almart_alkhdra-1#fullTextFileContent

Halacy, D. (1986) ‘Understanding Passive Cooling Systems’, VIT, p. 4.

Al-Baaj, A. K. A. L. (2008) ‘The Contemporary Vision of City Planning in Light of the Concept of Green Architecture’, Master’s thesis, Higher Institute of Urban and Regional Planning, University of Baghdad, p. 32.

Al-Najim, A. O. (2005) ‘The Contemporary Local Urban Environment and the Limitations of its Natural Ventilation’, article dated 1-2-2005, p. 3.

Bahjat Rashad Shaheen, “Architecture, City, Society”, First Arab Architecture Week, Arab Architects Association, Tunisia, 2008, p. 4).

Joseph, A. (n.d.) ‘Passive Solar Handbook- Introduction To Passive Solar Concepts’, Architectural Energy Corporation, Vol. I, p. 26.

Almusaed, A. (2011) ‘Bioclimatic Architecture: Analytical Therapy for the Next Generation of Passive Sustainable Architecture’, Springer, p. 333.

Hajer Abdel Samie, “Bio-climatic solutions and their role in achieving sustainable environmental design”, Master’s thesis, Department of Architecture - Baghdad, 2012, p. 69).

Almusaed, A. (2004) ‘Intellegent Sustainable Strategies Architecture upon Passive Bioclimatic Houses’, Arkitektskole Arhus, Denmark, p. 56.

AL-Sagaf, M. A. (2009) ‘Architecture of Hot Zones and Utilization of Solar Energy (Case Study in One of Hadramout Governorate – Al-Mucalla City)’, Journal of Engineering Sciences, Assiut University, Vol. 37, No. 5, pp. 1209-1234. Available at: https://jesaun.journals.ekb.eg/article_128180_49f52e6bf9a46919b3f8e8460bc214b5.pdf

Beygo, K. and Yüzer, M. A. (2017) ‘Early Energy Simulation of Urban Plans and Building Forms’, ITU A|Z, Vol 14, No 1, pp. 13-16.

Santamouris, M. (2005) ‘Passive Cooling of Buildings’, Group Building Environmental Studies, Physics Department, University of Athens, Athens, Greece, p. 13.

Gordon, R. and Richard, G. (1997) ‘Are Compact Cities a Desirable Planning Goal?’, Journal of American Planning Association, p. 17.

https://www.lowtechmagazine.com/2012/03/solar-oriented-cities-1-the-solar-envelope.html

Pearlmutter, D. (2001) ‘Pattern of Sustainability in Desert Architecture’, ARIDLAND, No. 47, pp. 14-15.

Al-Bayati, S. F. (2007) ‘Traditional Solutions for Sustainable Climate Adaptation and Their Employment in Contemporary Housing’, Master’s Thesis, Department of Architecture, University of Baghdad, p. 80.

Fathi, H. (1988) ‘Natural Energies and Traditional Architecture’, Arab Foundation for Studies and Publishing, pp. 118-119.

Moughtin, C. (1996) ‘Urban Design: Green Dimensions’, Architectural Press, p. 169.

Rahamimof, A. and Bornstein, N. (1981) ‘Edge Conditions Climatic Considerations in the Buildings and Settlements’, Energy and Building Journal, No. 4, pp. 43-49.

Fardeheb, F. and Schoen, R. (1988) ‘Design Guidelines for Communities in Hot and Arid Climate of Third World Countries’, Beld, Yugoslavia, p. 380.

Al-saffar, N. M. A. and Musa, H. H. (2019) ‘Sustainable Development and Renewable Energies and Their Application in Some Modern Residential Complexes’, Plant Archives, Vol. 19, Supplement 2, pp. 270-275. Available at: https://plantarchives.org/SPL%20ISSUE%20SUPP%202,2019/48%20(270-275).pdf

Anas, H. H., Al-Alwan, H. and Oukaili, N. (2021) ‘Free-form geometries in contemporary architecture – dimensional rules of Folded, Blob and Formlessness architecture’, IOP Conf. Series: Materials Science and Engineering, 1058, 012043. doi:10.1088/1757-899X/1058/1/012043.

Downloads

Published

2024-09-25

How to Cite

Musa, H. H., Asadi, F., & Majeed, A. H. (2024). The Impact of Wind Movement on Providing Thermal Comfort in Urban Design. Technium: Romanian Journal of Applied Sciences and Technology, 24, 39–57. https://doi.org/10.47577/technium.v24i.11740